Izdelki za mepitel mepilex (2)

20,00 x 10,00 x 3,00 x 3,00 mm - 100,00 x 50,00 x 6,00 x 6,00 mm, DIN EN 10279 (DIN 1026), Abnahmeprüfzeugnis nach DIN EN 10204 / 3.1, AD 2000 - W2 / W10 4,00 - 6,00 m Werkstoffe: 1.4301/1.4307/TP304/TP304L 1.4571/ TP316Ti 1.4401/1.4404/TP316/TP316L 1.4541 / TP 321 1.4305 /TP303

In the injection moulding process TPE pellets are fed into the machine through a hopper and then into a heated barrel. The heat from the barrel turns the material into a liquid resin which is then injected into a closed mould under high pressure. After allowing the molten polymer to cool, the finished part can be removed from the mould. Injection moulding is a high-volume, high tooling cost process, the advanced properties of our TPE compounds deliver short cycle times allowing parts to be produced at a rapid rate. The information below is intended as a general overview, settings may vary depending on the specific grade selected. Please CONTACT US for detailed processing information Settings Equipment Conventional injection moulding machine Compression set At least 2:1. Special screws with short sections and higher compression ratios (3:1 to 4:1) may be good at low screw speeds Shrinkage Between 1.0% and 2.5% depending on the grade, type of application and location of the gate. Moul